Project location by coordinates

What it is

You can set a project’s location by postal address or, if the site has no address (open lots, unnumbered industrial plots, linear works), by entering coordinates directly.

How to use it

Open the project settings.
In the location field, instead of searching for an address, enter coordinates directly.
Supported formats:
- Decimal (e.g. 40.4168, -3.7038)
- Degrees, minutes, seconds (DMS)
- UTM

The project is positioned on the map using those coordinates, without needing a recognized postal address.

Use cases

Sites on open lots or plots without numbering.
Industrial estates with incomplete addresses.
Linear works (roads, power lines, pipelines) where a single address doesn’t represent the project well.